Hi working my way around getting jobs done on my 230 just had the engine alignment sorted out after having low speed wobble , turned out when we did it that all adjusting nuts seized and Arvor factory had - get this - "packed out " with penny washers the engine mount feet between engine mount and boat hull - classic !!!
Out come - fitted 4 new upgraded strength feet , cleaned up thoroughly the threads on engine mount feet and made 10mm thick solid plates to over come height adjustment on thread issue so the 40mm nuts could adjust without running out of thread !
Previous owner had had prop re pitched and balanced to aide situation
Final result is upgraded mounts now give smoothness from idle to top end
Anybody with any vibration at any speed , Check the prop and cutless then have the alignment check done , transforms the boat job done !
Best regards
Stu
↧
Arvor 230
↧